Block seating and guide-motion rehearsal

MFG-CV01-P02 · Concept training procedure draft · D1 · 29 October 2026

For the inert browser model only. Not an approved operating SOP. No physical work, production release or certification is authorised.

Equipment MFG-CV01 · model 1.0.0-concept · source: original concept, approved SOP absent.

1. Confirm equipment and task identity.

   MFG-CV01 · Conveyor changeover rig. Record draft D1 and model 1.0.0-concept.

   Hold if: Identity, source applicability or required evidence is missing or inconsistent.

2. Confirm the inert training boundary.

   For the inert browser model only. Not an approved operating SOP. No physical work, production release or certification is authorised.

   Hold if: Identity, source applicability or required evidence is missing or inconsistent.

3. Inspect PIN-01 and PIN-02 with the component picker.

   Both locating features must be identified before discussing seating.

   Hold if: Identity, source applicability or required evidence is missing or inconsistent.

4. Select GB-B2 and use Block lift.

   Separate the block in the model; this is a visual training motion.

   Hold if: Identity, source applicability or required evidence is missing or inconsistent.

5. Orbit below the lifted block.

   Inspect the open underside and illustrative receiver geometry.

   Hold if: Identity, source applicability or required evidence is missing or inconsistent.

6. Compare each receiver with the two locating pins.

   The geometry shows a relationship; source-defined clearance and fit remain unverified.

   Hold if: Identity, source applicability or required evidence is missing or inconsistent.

7. Return Block lift to zero.

   Record the assembled illustration without claiming a measured seated condition.

   Hold if: Identity, source applicability or required evidence is missing or inconsistent.

8. Use Guide travel and identify RAIL-L / RAIL-R.

   The channels translate the concept rails symmetrically; the belt stays stopped.

   Hold if: Identity, source applicability or required evidence is missing or inconsistent.

9. Inspect HW-01 and both carriages.

   The visible handwheel is a named reference; native pivot/coupling acceptance belongs to Jan.

   Hold if: Identity, source applicability or required evidence is missing or inconsistent.

10. Stop at the first-piece evidence gate.

    Require the approved setting and physical check criteria before any real acceptance.

    Hold if: Identity, source applicability or required evidence is missing or inconsistent.

11. Prepare the evidence record.

    Record observations, source revisions, holds, recovery and missing physical evidence; do not invent a result.

    Hold if: Identity, source applicability or required evidence is missing or inconsistent.

12. Request qualified review before reuse.

    Keep this draft unapproved until the task owner accepts the sources, geometry, criteria, permissions and revision.

    Hold if: Identity, source applicability or required evidence is missing or inconsistent.

Qualified source, geometry and procedure review required before operational reuse.